Need help?Do you have a question about the Sundstrom SR 99-1 and is the answer not in the manual?
General| IP Rating | IP54 |
|---|---|
| Product Type | Respirator |
| Approval | EN 12941 |
| Filter Class | P3 |
| Noise Level | Approx. 70 dB(A) |
Ensures breathable air meets purity standards for impurities, oil content, and dew point.
Details the filter's two outlets, one of which is pre-plugged for delivery.
Specifies the inlet thread as 1/2" BSP female and the need for a suitable coupling.
Explains the automatic drain and manual operation via the pre-collector.
Advises noting the label date on the filter housing to track element change intervals.
Describes keyhole mountings for wall mounting and standing the unit on a surface.
Instructs to shut off air inlet and turn pre-collector to depressurise the filter.
Details loosening the hose between regulator and filter lid by pushing the red sleeve.
Explains unscrewing knobs to remove the filter housing lid.
Guides on removing the used filter element and cleaning the housing if necessary.
Advises checking seals for damage and replacing them if necessary.
Instructs on fitting the new filter element, noting its reversible orientation.
Guides on refitting the filter cover after element replacement.
Instructs on reconnecting the hose between the control valve and filter lid.
Ensures pads on cover and end caps fit correctly into their grooves.
Details tightening knobs alternately by hand until the lid meets the housing.
Instructs to shut off air inlet and turn pre-collector to depressurise the filter.
Guides on removing the drain bowl via bayonet mounting and cleaning it with hot water.
Explains how to remove the pre-collector element by turning it anti-clockwise.
Advises blowing parts clean with compressed air and checking the drain outlet for obstruction.
Instructs to shut off air inlet and turn pre-collector to depressurise the filter.
Guides on removing the drain bowl via bayonet mounting and cleaning it with hot water.
Advises blowing parts clean with compressed air and checking the drain outlet for obstruction.
To Next Page
