Sunex HD 5712 - User Manual

5712 - 12 Ton Hydraulic Shop Press
5720 - 20 Ton Hydraulic Shop Press
5720AH - 20 Ton Air/Hydraulic Shop Press
Sunex Part No. Total Height Inside Width Press Feet Length Bed Width Ram Stroke Pin Diameter Press Plates Included
5712 61.5" 20" 26" 8.75" 5" .75" Y(2)
5720 64.5" 24.5" 26" 11.25" 5.125" 1" Y(2)
5720AH 64.5" 24.5" 26" 11.25" 5.125" 1"
Y(2)
PRESS SPECIFICATIONS
5712, 5720, 5720AH rev. 10/03/18
OWNER'S MANUAL
CONTENTS:
Page 1 Specifications
2 Warning Information
3 Parts List
4-7 Assembly Instructions
8
9
10
Operating Instructions and Preventative Maintenance
Replacement Parts List
Warranty Information
© Copyright 2018, Sunex Tools
®

Summary

Warning Information and Safety

Nature of Hazardous Situations

Methods to Avoid Hazardous Situations

Lists precautions and safe practices to prevent injuries and damage.

Consequences of Not Avoiding Hazards

Highlights severe risks from not following safety guidelines.

Assembly Instructions

Securing Press Bed and Bleeding Air

Steps for securing the bed and removing air from the hydraulic system.

Pump Operation Procedures

Manual Pump Operation (5712 & 5720)

5720 AH Operation Modes

Operating and Maintenance Guidelines

Safe Operation Procedures

Essential safety guidelines for operating the shop press.

Press Bed and Air Purge Procedures

Covers adjusting bed height and purging air from the hydraulic system.

Preventative Maintenance Schedule

Sunex HD 5712 Specifications

General

Model	HD5712
Free Speed	8000 RPM
BPM	1200
Type	Impact Wrench
Drive Size	1/2 inch
Length	7.5 inches
Air Inlet	1/4" NPT
Min Hose Size	3/8 inch