Sunex HD 5712 - Tools Needed

5712 - 12 Ton Power Unit
5720 - 20 Ton Power Unit
5720AH - 20 Ton Pneumatic Power Unit
5712 - (2) 3/4" x 10" Pins
5720 - (2) 1" x 12" Pins
5720AH - (2) 1" x 12" Pins
5712 - (2) 1" x 2" x 10" Plates
5720 - (2) 3/4" x 3" x 12" Plates
5720AH - (2) 3/4" x 3" x 12" Plates
Examine box contents, then proceed with the following instructions.
ESTIMATED ASSEMBLY TIME: 30 MINUTES
TOOLS NEEDED
1/2" and 5/16" Box Wrenches
ACCESSORIES
PARTS LIST
Press Frame - 1
Press Bed - 1
Press Feet - 2
Z Bar - 1
1/2"-13 x 1-1/2" Hex Head Bolts - 4
1/2" Nuts - 4
Washers - 4
5/16"-13 x 1" Hex Head Bolt - 1
Press Pins - 2
Power Unit - 1 (5712 & 5720 ONLY)
Pneumatic Power Unit - 1 (5720AH ONLY)
Pump Handle & Extension - 1
2" Punch - 1
Accessory only -
Not needed for assembly
Bearing Shield - 1
Accessory only -
Not needed for assembly
Press Plates - 2
Accessory only -
Not needed for assembly
5712, 5720, 5720AH rev. 10/03/183
5712 - 12 Ton Hydraulic Shop Press
5720 - 20 Ton Hydraulic Shop Press
5720AH - 20 Ton Air/Hydraulic Shop Press