Sunex Tools 1003 Operating Instructions

1003/1006 1 REV. 8/29/06
SPECIFICATIONS
1003 1006
Capacity 3 Ton 6 Ton
Low Height 11.25" 15.5"
Raised Height 17" 24"
Base 7.5" x 7" 9.75" x 11"
Shipping Weight 16 lbs./pr. 38.5 lbs./pr.
ASSEMBLY INSTRUCTIONS:
Remove both stands and ratcheting posts from box.
Insert posts into stands. Bend in tab on side of
collar using a punch and hammer. Lift release lever
and lift ratcheting bar to desired height. Check to
make sure the dog engages each tooth properly on
the ratcheting post.
INSPECTION:
Visual inspection should be made before each
use of the stand. Any stand which appears to be
damaged in any way, found to be badly worn,
or operates
abnormally,
MUST BE REMOVED
FROM SERVICE.
If the stand is accidentally
subjected to an abnormal load or shock, it must
be inspected by a manufacturer’s authorized
repair facility immediately. It is recommended that
an annual inspection of the stand be made by a
manufacturer’s authorized repair facility and that
any defective parts, decals, or warning labels be
replaced with manufacturer’s specified parts. All
repairs must be made by a factory authorized
service center. A list of authorized repair facilities is
available from
the manufacturer.
OWNER/USER RESPONSIBILITY:
The owner and/or user must have a thorough
understanding of the manufacturer’s operating
instructions and warnings before using the Vehicle
Support Stands. Personnel involved in the use and
operation of equipment shall be careful, competent,
trained, and qualified in the safe operation of the
equipment and its proper use when servicing motor
vehicles and their components. Warning information
should be emphasized and understood. If the
operator is not fluent in English, the manufacturer’s
instructions and warnings shall be read to and
discussed with the operator in the operator’s native
language by the purchaser/owner, making sure that
the operator comprehends its contents.
Owner and/or user must study and maintain for
future reference the manufacturer’s instructions
and pertinent warning information. Owner and/
or user is responsible for keeping all warning
labels and instruction manuals legible and intact.
Replacement labels and literature are available from
the manufacturer.
MAINTENANCE INSTRUCTIONS:
Oil all release handle moving parts and be sure they
continue to work properly.
D
O NOT OVERLOAD STAND. OVERLOADING CAN CAUSE DAMAGE TO, OR FAILURE
OF, THE STAND.
PLACE LOAD IN THE CENTER OF THE SADDLE ONLY.
USE STANDS IN PAIRS, ON HARD, LEVEL SURFACES CAPABLE OF SUSTAINING
THE LOAD.
LOAD AND STANDS SHALL BE STABLE. USE ON OTHER THAN HARD, LEVEL
SURFACES MAY RESULT IN POSSIBLE LOSS OF LOAD.
INSPECT EACH STAND TO BE SURE IT IS IN GOOD CONDITION BEFORE USE.
NO ALTERATIONS TO THE STAND SHALL BE MADE.
USE SUPPORT POINTS SPECIFIED BY VEHICLE MANUFACTURER.
DO NOT CRAWL UNDER VEHICLE WHEN PLACING/REMOVING STANDS.
ENSURE BOTH STANDS ARE SET AT SAME HEIGHT AND HOLDING DOGS ARE
FULLY ENGAGED.
READ, STUDY & UNDERSTAND THE OPERATING MANUAL PACKED WITH THIS
STAND BEFORE USING STAND. FAILURE TO HEED THESE WARNINGS MAY RESULT
IN LOSS OF LOAD, DAMAGE TO STAND, AND/OR FAILURE RESULTING IN PROPERTY
DAMAGE, PERSONAL OR FATAL INJURY.
MODEL 1003/1006
3 and 6 Ton Capacity Jack Stand
Operating Instructions • Warning Information • Parts Break down
10031006_081906.indd 1 9/6/06 1:49:56 PM

Sunex Tools 1003 Specifications

General

Brand	Sunex Tools
Model	1003
Category	Other
Language	English