What to do if my Sunex Tools 6602ASJ unit will not lift rated load?
If your Sunex Tools Lifting Systems unit fails to lift the rated load, purge air from the hydraulic system by following the procedure described under SETUP.
Why does the handle tend to raise up while the Sunex Tools 6602ASJ unit is under rated load?
If the handle tends to raise up while the unit is under a rated load, rapidly pump the handle several times. This action helps to push oil past the ball valves in the power unit.
What to do if my Sunex Tools 6602ASJ Lifting Systems unit will not sustain rated load or feels “spongy” under rated load?
If your Sunex Tools Lifting Systems unit will not sustain the rated load, or if it feels "spongy" under the rated load, purge air from the hydraulic system as described in the SETUP section.
How to fix a Sunex Tools Lifting Systems unit that will not lift to full height?
To resolve the issue of a Sunex Tools Lifting Systems unit not lifting to its full height, purge air from the hydraulic system following the procedure outlined in the SETUP section.
Discusses inherent hazards of lifting devices requiring user intelligence, care, and common sense.
Provides critical safety practices like reading manuals, inspecting equipment, using proper surfaces, and supporting loads.
Explains potential severe outcomes from neglecting safety warnings and instructions.
Explains the SUNEXpress™ warranty for exchanging defective service jacks within one year.
Details monthly or as-needed maintenance tasks like lubrication and tightening hardware.
General| Brand | Sunex Tools |
|---|---|
| Model | 6602ASJ |
| Category | Lifting Systems |
| Language | English |
To Next Page
