User's Manual
26
GUIDE MENU
MODEMODE
EXIT INFO
SYSTEM
+10
POWER
31
64
97
ENTDIS
M3M1
2
5
8
0
M2
PAG E
FAV
MAIN
OFF
VOL CH
MUTE
PREV
CH
CD
AUDIO
MAIN
TAPE
AUX
ZONE2
TGIII
DVD
VCR
SAT
TV
CABLE
CHAPTER 3
1. Press the remote's MAIN button
to make sure the display is on the
main display menu.
2. Press the TGIII de-
vice button to set
the remote to oper-
ate your TGIII. The
display chang es
to show the TGIII
input se lec tions:
3. Press PAGE to
reach page 2,
which shows the
PRO LOGIC-II,
PAR TY, STE REO,
HO LO GRAM, and
the trims for center,
sur rounds, and sub.
On the right is '+'
(in crease level) and
on the left is '-' (de-
crease level).
4. The fol low ing but tons with fi xed la-
bels are also pro grammed: Pow er,
Vol ume up, down and Mute. The
number pad accesses the tuner
presets directly, and CH+/- steps
through them. DIS is the +10 func-
tion, and ENT is station enter. The
MODE buttons either side of the
joystick, allow you to select the dif-
ferent surround modes.
ZONE 2
1. From the main
display menu, press
the ZONE2 device
button to access fea-
tures of the second
zone. Page 1 shows
the input selections.
2. The hard buttons op-
erate Zone 2, such
as Power, Volume,
Mute, and the Tuner controls and
presets.
3. Page 2 shows
Zone 2 on/off,
Zone 1 on/off,
and balance left/
right.
Note: Zone 2 must
fi rst be enabled
using the OSD
(see page 36), or
these controls will have no effect.
Zone 2 can be turned on even if
the Main Zone is off.
See page 47 for more Zone 2 details.
Operating the TGIII with the Remote
MAIN
PAGE
TGIII
ZONE 2
Previous Mode
Next Mode
Full-page On Screen
Display (OSD)
Momentary status and
information display
OSD Exit
Use the Joystick to navigate
through the OSD (when active)
Hold down MAIN and
ENT for a few seconds
to enter the SETUP
mode. See next page.
ENT
To Next Page
Loading...
