Sungrow SC50HV Quick Installation Guide

1
SC50/60/75HV Quick Installation
Guide
This guide provides a general instruction of the installation procedures of
SC50/60/75HV.
In no case shall this guide substitute for the user manual or related notes on
the device.
Make sure to read over, fully understand and strictly follow the detailed
instructions of the user manual and other related regulations before installing
the equipment. The user manual can be downloaded by visiting the website
at http://support.sungrowpower.com/; or it can be obtained by scanning the
QR code on the side of the equipment or the back cover of the Quick
Guidance.
Any violation could result in personal death or injury or device damage.
1 Unpacking and Inspection
Step 1 Remove the backplate and fasteners from the packaging.
Step 2 Inspect the converter for visible damages and check the
completeness of the delivery contents according to the inner
packing list.
Contact your supplier if any of the contents is missing. The converter
is unavailable if any damage is detected.

Sungrow SC50HV Specifications

General

Model	SC50HV
Max. Input Voltage	1100 V
Input Voltage Range	200 V - 1000 V
MPPT Voltage Range	200 V - 1000 V
Rated Power	50000 W
Rated Output Voltage	400 V
Nominal Grid Frequency	50 Hz / 60 Hz
THDi	< 3%
Max. Efficiency	98.7%
Protection Degree	IP65
DC Connection Type	MC4
Rated AC Output Power	50000 W
AC Voltage Range	480 V
Output Frequency	50/60 Hz
Operating Temperature Range	-25 °C ~ +60 °C
Cooling Method	Forced air cooling
Protection Level	AC Surge Protection
AC Connection Type	Terminal block
Humidity Range	0 - 100%
Communication	RS485 / Ethernet