28
• Please ensure that the optimizer is installed facing the back of the module. Oth-
erwise, the clip may get damaged.
• Do not forcibly bend the clips when installing the optimizer by clips. Otherwise,
the clip may be damaged.
• Do not clamp the optimizer into holes in the module frame during installation.
Otherwise, the optimizer cannot be removed or the clips may be damaged.
• It is recommended to install optimizers on the same side of modules.
• Do not clamp and remove the optimizer multiple times. Otherwise, the clip may
become loose, affecting normal use.
- - End
4 Mechanical Mounting User Manual
To Next Page
Loading...
