What to do if my Sunlover Heat Pump shows a flow switch failure?
If the Sunlover Heat Pump displays a flow switch failure, it could be due to insufficient water in the water system. Check the water flow volume and verify the water pump's functionality.
Why does my Sunlover Heat Pump show high pressure protect?
The 'High pressure protect' error on your Sunlover Heat Pump indicates that the exhaust pressure is too high, triggering the high-pressure switch. You should check the high-pressure switch and the cooling return circuit.
Why does my Sunlover Heat Pump show low pressure protect?
The 'Low pressure protect' error on your Sunlover Heat Pump means the suction pressure is low, activating the low-pressure switch. Check the low-pressure switch and the cooling return circuit.
What to do if the Sunlover Heat Pump displays a communication failure?
If your Sunlover Heat Pump is showing a communication failure, it means there's a communication issue between the remote wire controller and the main board. You should check the wire connection between these two components.
What to do if the temperature difference is too much between water-inlet and outlet in Sunlover Oasis X 19 Heat Pump?
If there's a significant temperature difference between the water inlet and outlet in your Sunlover Heat Pump, it might be caused by insufficient water flow or a small water system pressure difference. Check the flow volume and ensure the water system isn't jammed.
What causes antifreezing under cooling mode in a Sunlover Oasis X 19 and how to fix it?
Antifreezing during cooling mode in your Sunlover Heat Pump can occur if the water flow volume is not enough. You should check the flow volume and ensure the water system is not blocked.
What to do if my Sunlover Heat Pump has a water inlet temp sensor failure?
If your Sunlover Heat Pump indicates a water inlet temperature sensor failure, it's likely that the sensor is either open or short-circuited. You should check or replace the water inlet temperature sensor.
What to do if my Sunlover Heat Pump has a water outlet temp sensor failure?
If your Sunlover Heat Pump reports a water outlet temperature sensor failure, the sensor is likely open or short-circuited. You should check or replace the water outlet temperature sensor.
How to fix ambient temp sensor failure in Sunlover Oasis X 19?
If your Sunlover Heat Pump shows an ambient temperature sensor failure, it means the sensor is either open or short circuit. To resolve this, check or change the ambient temperature sensor.
What does evaporator temp sensor failure mean on my Sunlover Oasis X 19?
An evaporator temperature sensor failure on your Sunlover Heat Pump indicates that the sensor is either open or short circuit. To fix this, check or replace the evaporator temperature sensor.
Presents technical performance metrics for heating and cooling capacities.
Guides on proper electrical connections, grounding, and circuit protection.
Step-by-step instructions for the first-time power-up and operational checks.
Details the procedure for safely starting up and shutting down the heat pump unit.
Guides users on adjusting the desired water temperature for the pool.
Step-by-step guide on setting the automatic on/off timer for the unit.
How to interpret error codes displayed on the controller and find solutions.
A guide to diagnose and resolve common problems with the heat pump unit.
Essential safety advice, warnings, and precautions for installation and operation.
To Next Page
General