SUNLU SL Series - Filament Loading

7. Filament Loading
Step1： Nozzle preheating（PLA：195℃，ABS：220℃）, Menu → Control → Temperature → Nozzle →
Setting Temp.（>190℃）.
Step2：Press and hold the extruder lever then insert the 1.75mm filament through the small hole of the extruder.
Continue feeding until you see filament come out the nozzle.(Pic 15, Pic 16).
Please make sure that the end point is about 45 degree angle.(Pic 14 )
Pic14 Pic15 Pic16
Hold down
10