5.0 Installation
Precautions and general safety rules
◼ Before installing the modules, please complete a specific site engineering review
to ensure the proposed methodology complies with local laws, regulations and or
constructions standards.
◼ Check the applicable building codes to ensure that the building is suitable for
SunMan installation.
◼ During installation, make sure that the modules are installed on a fire-resistant
roof. According to UL790 standards, SunMan modules are rated as fire rating
C.
◼ The modules are compliant with application level A (equivalent to safety level
II, IEC 61730-1). This type of modules can be used in systems where the
public is likely to come into contact with voltages greater than 50V or power
greater than 240W.
Environmental conditions
The modules are suitable for general climatic conditions, ie with reference to IEC
60721-2-1- Classification of environmental conditions Part 2-1: Environmental
conditions occurring in nature - temperature and humidity.
◼ If the modules are used in a special installation environment, please consult
the technical support department of SunMan in advance.
◼ The installation surface should be flat without bumps or pits.
◼ The modules must not be installed near flames or flammable objects.
◼ Do not expose modules to artificial condensing light sources
◼ The modules should not be immersed in water (pure water or salt water),
installed in long-term water environment (pure water or salt water) (eg
fountains, sprays, etc.) or area prone to water accumulation (eg roof drain, low-
lying areas, etc.).
◼ If the module is placed in a salt mist (ie marine environment) or in an
environment containing sulfur (ie, sulfur sources, volcanoes, etc.), there is a
risk of corrosion.
◼ Failure to follow the above precautions, SunMan Warranty will be voided.
Installation requirements
◼ Ensure the modules meet the overall technical requirements of the system.
To Next Page
Loading...
