© 2024 SunMan (Zhenjiang) Company Limited. All rights reserved. Specifications included in this manual are subject to change
without notice.
www.sunman-energy.com
version SMH-2024B page28 / 29
8. Module Stacking and Transportation Method:
If modules are not immediately installed after unpacking and need to be laid flat, place
paper honeycomb pads on the pallet, followed by honeycomb separator strips, and then lay a
single module flat on top (solar cell side up), with paper honeycomb pads on it. Stack the
remaining modules in the same manner, with no more than 20 layers in height.
The stacked modules must be aligned to prevent tilting and falling during transportation.
When carrying individual modules, two people should operate together, handling them
gently.
To Next Page
Loading...
