1.Insert the power cord, apply the clean water and the detergent into the clean water tank, and add the defoaming agent to the
sewage tank.
2. Press the a\b\c switches respectively to start the work.
3. The power plug must be connected to the socket with the grounding wire and the electric leakage
protection..
Turn off the brush tray motor when the brush plate is in the upward position.
How to Turn On and Turn Off the Water Suction Motor
1.The water suction motor will be started by pressing down the（I）of the left switch (C).
2.The water suction motor will be turned off by pressing down left switch（O）.
Brush Tray Lifting
1.Tread the lifting pedal of the brush tray （4）downward until it is locked in the right position.
2.Tread the lifting pedal of the brush tray（4） lightly to unlock it and then slowly lift it up to lower the pedal.
Squeegee Lifting
1.Pull the handle down to lower the water wiper.（3）
2.Pull the handle up to lift up the water wiper.（3）
Setting of the Clear Water Tank Flow/ Cleaning and Replacement of Clear Water Filter Adjust the water-
carrying capacity in accordance with the dirty degree of the floor. Rotate the adjusting knob （11）to control the water- carrying
capacity. The position 1
indicates where to turn off while the position 2 indicates the maximum water level.
Regularly clean the
dirt in the clear water filter
（
12
）
based on the frequency of use
（
recommended to clean once in 1-3 days.
），
and rotate to
disassemble according to the direction of the arrow. Filter body (k), filter (L), sealing ring (m), plug (n)
Machine Operating Instructions
a b c
To Next Page
Loading...