Water Suction Operation
1.Make certain the squeegee is in the downward position.
2.当The squeegee will draw the detergent into the sewage tank when the washing machine is moving forward to brush the floor.
3.If necessary, rotate the knob（8） to adjust the voltage of the squeegee.（切Do not make the angle of the red rubber sheet
of the squeegee too big. Otherwise the red rubber sheet will be worn more quickly, which shall affect the cleaning
situation. The greater the angle is bending, the greater the resistance will be.）
如
If areas need cleaning are missed, please decrease the use quantity of the cleaning solution and lift up the squeegee to pull the
washing machine back to the missing areas. Lower the squeegee and move it forward to draw the remaining cleaning solution on the
floor.
What
Should We Do When There Are Too Much Foam in the Sewage Tank
观Stop operating the washing machine if there are too much foam when you are observing the the situation of waste water
accumulation in the sewage tank. Add the recommended amount of chemical defoamer（19）to the sewage tank.
Sewage Tank Emptying
Open the sewage tank pipe weep（18）to empty the sewage tank（19）.
Daily Maintenance
1.Wash the sewage tank with clear water and empty it. Open the tank lid（21）to dry it.
2.Remove the water wiper components and wash and wipe it clean. Examine whether there have blockages or chippings in the
mouth of the water wiper.
3.Clean and wipe the top of the battery with ammoniated glass cleaner.
4.Fill each battery with distilled water as needed.Do not use tap water to fill the batteries. Maintenance- free storage batteries has
no need to add more liquids.
5.Charge the batteries according to the instructions listed on this handbook.
Weekly Maintenance
Do not test the strength of the batteries unless they are fully charged and fully
cooled. Test the batteries with a hydrometer.
Monthly Maintenance
1.Rinse and empty the sewage tank with clean water. Open the cover of the water tank (21) and dry
it with air.
2.Remove the water wiping element, rinse and scrub cleanly. Check if the water wiping inlet has
blockages or debris.
3.Keep the power plug and socket dry and check if the power cord is damaged or leaking the
electricity.
4.Check if the dust suction motor has debris or foreign body clogging.
5.Check if the filtering cotton of the suction nozzle in the sewage tank has foreign body clogging.
Maintenance
Operation of the Washing Machine
To Next Page
Loading...