To Next PageTo Next PageWhat to do if my Sunny SF-RBE4886 SMART shows error E4?
If you are getting an E4 error on your Sunny Exercise Bike, it could be due to a few reasons. First, make sure to place your hands on the pulse sensors right after pressing the START/STOP button. If that doesn't work, try plugging the pulse wires again or replacing them. As a last resort, consider replacing the meter.
What does error E2 mean on my Sunny Exercise Bike, and how can I fix it?
If your Sunny Exercise Bike displays an E2 error, it means no EEPROM data was read or there was an error reading the EEPROM data. Try reconnecting the meter. If that doesn't work, power the meter off and on again to re-read the data.
How to fix error E1-3 on Sunny SF-RBE4886 SMART?
If your Sunny Exercise Bike is showing error E1-3, it indicates that the motor's resistance level is too high. To resolve this, try these steps: 1. Plug in the cables and power on the bike. 2. Disconnect the cables after one second, then plug them back in. 3. Power the bike on again and wait about six seconds for the motor to return to its starting point. 4. Press the MODE and ENTER buttons simultaneously to enter correction mode and correct any errors.
What to do if Sunny Exercise Bike displays error E1-2?
If you're seeing error code E1-2 on your Sunny Exercise Bike, this indicates that the motor signal has no induction. Try plugging the cables again. If the problem persists, you may need to replace the motor.
General| Brand | Sunny |
|---|---|
| Model | SF-RBE4886 SMART |
| Category | Exercise Bike |
| Language | English |
Attaching front and rear stabilizers to the main frame using provided hardware.
Connecting the handlebar post and sensor wires to the main frame.
Installing the long axle and attaching swing bars to the handlebar post.
Connecting swing bars to pedal support tubes with spacers and nylon nuts.
Attaching pedal support tubes to the cranks using hinge bolts and nuts.
