SunPower SPR-P19-400-COM 400 - User Manual

Safety and Installation Instructions
United States and Canada
This document applies to all SunPower modules
listed in Table 1.
Contents of this manual are subject to change without notice.
For the latest US & Canada manual please refer to www.sunpower.com/PVInstallGuideUS
SunPower Corporation
www.sunpower.com
For the latest for Europe, Asia, Australia, Latin America and Africa manual please refer to
www.sunpower.com/PVInstallGuideIEC
For the latest US & Canada technical specifications please refer to
www.sunpower.com/PVResidentialSTS (for residential modules)
www.sunpower.com/PVCommericalSTS (for commercial and utility modules)
Document 001-14158 Rev AG
P/N 100345
P/N 518350
This document includes references to SunPower E-Series, X-Series, P-Series, A-
Series, MAX2, MAX3 and NE modules. These modules do not have grounding
restrictions and all are compatible with high-efficiency transformerless
inverters.

SunPower SPR-P19-400-COM 400 Specifications

General

Manufacturer	SunPower
Model	SPR-P19-400-COM
Power Output	400 W
Type	Monocrystalline
Operating Temperature Range	-40°C to +60°C

Summary

Introduction to SunPower PV Modules

Disclaimer of Liability

SunPower assumes no responsibility for loss, damage, or expense from improper installation.

UL Listing Information

Details UL 1703, ULC/ORD-C1703-01, UL1741, UL61730 compliance and mounting requirements.

Limited Warranty Overview

Summary of SunPower's Limited Warranties and exclusions for PV modules.

Safety Precautions

General Module Handling and Safety

Instructions on handling, preventing damage, avoiding shock hazards, and proper installation procedures.

Fire Rating Classification

Module fire rating is Type 2 per UL1703 and Class C per UL1703, dependent on mounting system.

Electrical Characteristics

Electrical Connections and System Monitoring

Equipment Grounding Procedures

Guides on grounding module frames using specified hardware and methods to prevent electrical shock.

System Grounding Guidelines

Series and Parallel Connections

NEC 2017 Rapid Shutdown Compliance

Module Mounting Requirements

Site Considerations for Module Mounting

Details environmental requirements, operating temperatures, and design strength for module installation.

Mounting Configurations and Load Ratings

Module Mounting Using Frame Holes

Instructions for securing modules to structures using factory mounting holes and specified hardware.

Module Mounting Using Clamps or Clips

Guidance on using IFF clips or other clamps for module mounting, including torque specifications.

Module Mounting Using End Mounts

Instructions for end mounting modules using IFF clips, focusing on torque and strength requirements.

Helix Mounting System Installation

Reference to UL2703 Helix system installation manual for details.

SunPower Specified Mounting Systems

Module Handling Precautions

Module Maintenance and Cleaning