SUNPRO Retractable Awning - Setting Wind Sensitivity Level

Wind Sensor Installation
30
Step 7 Step 8 Step 9
Now set your wind
level. We use #4
Mount the backing
plate into accessory
track on front
mounting bar. Use 1-
inch sheet metal flat
top Phillip’s head self-
tapping
Re-insert Black
control into housing
Step 10
Slide housing onto
mounting plate
Selecting a wind level:
1
2
3
4
5
6
7
8
9
Low
Medium
High
The greater the number, the more wind is required to activate the
sensor. It may be necessary to change the level selection to meet
your requirements. We use Default of #4
Note: When battery levels are below 2.2 volts, a warning beep will
sound every 5 seconds to replace the batteries.
Important: Mount Wind Sensor in Center of Front bar
If you need any assistance, please contact your local dealer.