文件编号 Document No.：SP/WI-JS-010
5.5、INSTALLATION METHOD 安装方法
5.5.1 MECHANICAL INSTALLATION AND WARNING 机械安装及注意事项
PV modules can be installed through clamp method.The modules must be installed according to the following
examples and recommendations. If a different installation method is desired, please contact YuHuan Sunpro
Solar customer service or technical support team for consultation. Improperly mounted modules maybe damaged.
If alternative mounting method is used that has not been approved by YuHuan Sunpro , the modules will not
continue to carry a valid warranty.
光伏组件的固定和安装可以采用压块固定方式。安装组件必须依照下面示例和建议进行，如果安装方式与玉环
尚博公示不同，请咨询玉环尚博技术支持或售后，并取得玉环尚博同意，否则会损坏组件并导致质保失效。
Modules shall not be subjected to wind or snow loads which is exceeding the maximum permissible designed
loads, and shall not be subjected to excessive forces due to the thermal expansion of the support structures. The
selection and design of mounting bracket shall be carried out by professional system engineers after the load
calculation according to the climatic conditions of the installation site.
系统设计过程中光伏组件不应承受任何超出最大设计载荷的负荷（如风和雪载荷），同时不应该承受因支架结
构的热膨胀而产生的过大的力。根据安装地气候条件由专业系统工程师进行载荷计算，然后对安装支架进行选择和
设计。
The modules depicted are mounted on continuous rails that extend beneath the modules. If modules are
mounted without continuous rails below them, the maximum allowable loading will be reduced and needs to be
subjected to review by YuHuan Sunpro.
所描述的组件被安装在组件下方延伸的连续支架上。如果组件被安装在没有连续的支架的情况下，那么最大的
允许载荷将会减少，由玉环尚博进行检查。
Please ensure that the modules with the same color cells to be installed together.
在组件安装过程中，建议使用相同色系的组件安装在一起。
A clearance of at least 115mm (recommended) is provided between modules and the surface of the wall or
roof.
建议在组件和墙面或屋顶表面之间留有至少115mm的间隙。
The minimum clearance between two adjacent modules must not be less than 10mm.
两块相邻组件之间的最小间隙不能小于10mm。
The module frame drain holes cannot be blocked in any situation during installation or use.
安装或使用过程中，排水孔在任何情况下都不能堵塞。
To maximize mounting longevity, YuHuan Sunpro Solar strongly recommends the use of corrosion proof
(stainless steel) attachment hardware.
为最大程度的延长安装寿命，玉环尚博建议使用防腐蚀（不锈钢）固件。
The installation method listed below are for your reference only, the PV system installer or the trained
professionals should take the responsibility of the PV system design, mechanical load calculation, install,
maintenance and safety, YuHuan Sunpro Solar will not supply the related material for system installation.
以下列出的安装方法仅供参考，系统安装商或经过训练的专业人士必须要对光伏系统的设计，机械载荷计算、
安装、保养和安全负责，玉环尚博不提供相关的安装材料。
. Mounting with Clamps 夹具安装
YuHuan Sunpro Power Solar has tested its modules with a number of clamps from different manufacturers,
with a mounting bolt of at least M8. The length of clamp ≥60mm, thickness ≥ 3mm. If the customer needs a
To Next Page
Loading...