EasyManua.ls Logo

SUNPRO SP520-144M10 - Handling Safety 操作安全

Default Icon
41 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
文件编号 Document No.SP/WI-JS-010
- 3 -
如果在表面玻璃损坏或背板磨损的情况下接触组件的表面或边框可能会引起触电。
11 Do not attempt to repair, disassemble or move any part of the PV module. The module does not
contain any reusable parts.
不要试图修复、拆解或移动组件中的任何部分,组件内没有用户可二次利用的元件
12 Do not connect or disconnect the module when it is energized or connected with an external power
supply. 当组件有电流或外部电流出现时,不得连接或断开组件。
2.3HANDLING SAFETY 操作安
1Do not stand, walk on or lean on the module directly.
禁止直接在包装或组件上站立、踩踏、行走或跳跃
2Do not damage or scratch the front or backside surfaces of the module.
请不要损坏或划伤组件的玻璃和背板面。
3 Do not drag. Scratch, bend the output cable with force or with too tight connection. The insulation of
output cable can break and may result in electricity leakage or shock.
请不要拉扯、划伤、用力弯折或过紧安装输出线缆,否则线缆的绝缘部分会被损坏导致电流泄露或触电。
4If there is an open fire, please extinguish it with a dry powder extinguisher after disconnecting the power
supply, can not use liquid such as water to extinguish the fire.
如有明火请在断开电源后用干粉灭火器扑灭, 不可用水等液体扑灭。
5Do not install or handle modules when they are wet or during periods of high wind.
请不要在潮湿或者大风期间安装或处理组件。
6At the installation site, take care to keep modules and in particular their electrical contacts, clean and
dry before installation. If connector cables are left in damp conditions then the contacts may corrode. Any module
with corroded contacts should not be used.
在安装现,请保组件器元件的洁与干。如线缆插头潮湿条件下互接触,会腐蚀。任何被
腐蚀的组件都不能被使用。
7 Please Do not loosen, unscrew or peel the PV module bolts and frame glue. This may lead to a
reduction of the module’s load rating and potential damage from a fall.
请不要松动、拧下、剥离,光伏组件的螺丝或边框胶,有可能导致组件载荷下降,甚至掉落。
8Do not drop PV modules or allow objects to fall down on the PV modules.
请不要让物体直击组件或物体直接掉落在组件上。
9 Do not touch the terminal box or the ends of the output cables (connectors) with bare hands under
sunlight, regardless of whether the PV module is connected to or disconnected from the system.
在阳光下请不要没有何保护的况下用直接摸组件的线盒、连接器线缆等带体,无论光伏
组件是否与系统连接。
10Do not discard the modules at will; special recycling is required. 禁止组件随意丢弃,需要专门回收。

Related product manuals