SUNPRO SP520-144M10 - Page 29

文件编号 Document No.：SP/WI-JS-010
- 26 -
载荷
36/48/54/60/72/108/110/
120/132/144pcs Module
36/48/54/60/72/108/110/
120/132/144片Module
+5400Pa/-2400Pa
A=1/4L±50mm
；
L=Module length
*NOTE:
1. The crossbeam is perpendicular to the long side frame.
横梁与组件长边垂直
2. The above described distance is from the module edge to the
middle of the clamp. Clamps length ≥60mm.
所述距离为组件边缘到夹具中心的距离。夹具长度≥
60mm
3. Need two support rails below the PV module to make sure the
Mechanical load.
组件下面需要两个支撑轨，以确保机械载荷。
4. The load is an empirical value of a standard module based on
a standard installation mode, and the specific information shall
be consulted by YuHuan Sunpro Power Solar.
A=1/5L±50mm；L=Module width
1. The crossbeam is perpendicular to the short side frame.横梁
与组件短边垂直
2. The above described distance is from the module edge to the
middle of the clamp. Clamps length ≥60mm.
所述距离为组件边缘到夹具中心的距离。夹具长度≥60mm
3. Need two support rails below the PV module to make sure the
Mechanical load.
组件下面需要两个支撑轨，以确保机械载荷。
所述载荷为标准组件基于标准安装方式下的经验值，具体
信息还需咨询玉环尚博。
*NOTES:
Other mounting configurations can be used. However, failure to comply with the above recommendations will
result in a lowering of the load handling capabilities below the empirical value, and product failure as a result of an
overload situation will not be covered by the YuHuan Sunpro Solar warranty.
注意：可以使用其他安装配置，但不遵守上述建议将会导致组件载荷能力低于经验值，产品因过载失败不会享
受玉环尚博质保。