www.sunred.nl
4
Base Assembly
Heating Element Assembly
Knob
Upper Post Assembly
Middle Post
Lower Post Assembly
Tube Cover
Clamp
Power Cord
Power Cord
5
Heating Element Assembly
Body
4 Join the Heating Element Assembly
(1) and the Upper Post Assembly (7)
together ,then fix them tightly by
rotating the Knob, and put the power
cord supply into the clamp.(fig.4)
5 According to the request of use angle,
Heating Element Assembly can adjust
Angle at 0º~45º.(Fig.5)
OPERATION
The appliance is switched on by means of the pull switch (5). The slight vibration noticeable when the appliance is switched on will stop
after a few seconds.
6-OUTPUT
-Position 0: Stop
-Position 1: 650W (normal power)
-Position 2: 1300W (intermediate power)
-Position 3: 2000W (full power)
MAINTENANCE
Your appliance dose not requires any particular maintenance. However, in the event of a malfunction, please consult an Approved
Service Center.
1， This appliance is not intended for use by persons (including children) with reduced physical,sensory or mental capabilities.or
lack of experience and knowledge,unless they have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
2， Children should be supervised to ensure that they do not play with the appliance.
To Next Page
Loading...
