Sunrise IW-45M User Manual (English)

Other manuals for Sunrise IW-45M

Questions and Answers:

Lauren GlennAug 4, 2025

What to do if Sunrise Lathe motor cannot start?

K
Kristine LewisAug 4, 2025
If the motor of your Sunrise Lathe doesn't start, there are several potential causes. First, check the power source to ensure it's properly connected. Verify that the isolator switch is in the ON position. Make sure that both emergency buttons are released by turning the knob to the right. Inspect the motor power cable for proper connection and replace it if it's worn. Also, check if the motor circuit breaker has tripped to the OFF position and reset it if necessary. Examine the fuse and replace it if broken. Finally, the motor, magnetic switch, or transformer might be broken, requiring replacement.

Lauren SimpsonAug 18, 2025

Why Sunrise Lathe motor is on, but machine won't move?

N
Natasha DavisAug 18, 2025
If the motor of your Sunrise Lathe is running but the machine isn't moving, several issues could be the cause. It's possible the motor is turning in the wrong direction; turn the machine off, change any two of the three power source wires, and re-check the motor direction. Insufficient hydraulic oil could also be the problem; check the oil level and add oil if needed. A stuck solenoid valve can prevent movement, so clean or replace the valve. Also, a burnt out solenoid valve coil or a stuck/burnt out relay will require replacement. Ensure the interlocked safety covers are closed and that the limit switch is set at the correct position for proper stroke travel setting. Finally, check the foot paddle and replace the switch if it's not sending a signal.

Model

IW-45M

Capacity

45 kg

Max Temperature

90°C

Power Supply

380V/50Hz

Material

Stainless Steel

Heating System

Electric

Certification

Operating Temperature

5°C to 40°C