Page 5 www.sunrotor.com
3 WARNINGS
Please review the following warnings. These are listed for both personal safety and the safety of the
products. Disregarding or ignoring these warnings can result in SERIOUS INJURY and/or VOID YOUR
WARRANTY. All SunRotor
®
Solar Pumps should be installed by a licensed pump installer. If this
system is being installed without a licensed pump installer, an electrician or knowledge of electrical
circuits is HIGHLY recommended. If any questions or concerns regarding these warnings should arise,
please contact your Authorized SunRotor
®
Dealer or the SunRotor
®
Technical Services Team at 1-580-
303-4015. Solar Power & Pump Company, LLC is NOT LIABLE for any DAMAGE or INJURY.
All SunRotor
®
controllers have a maximum voltage rating. Exceeding these ratings will destroy the
controller and void the warranty. Do NOT exceed the following open circuit voltages: SRC-M50T:
50VDC; SRC-M100T: 100VDC; SRC-M200T; 200VDC. For all other controllers, please contact the
SunRotor
®
Technical Services Team. See Section 9.2 Wiring the Controller.
The system should be installed and serviced by qualified personnel only. All electrical codes should be
observed. Make ABSOLUTELY CERTAIN all power sources are disconnected prior to wiring.
Extreme heat can damage the pump. Protect the pump from sunlight or other heat sources.
SunRotor
®
solar pumps are CLEAN WATER PUMPS. Extreme sand or silt may cause the pump to stop or
fill the pipe with debris. Running it under these conditions may damage the pump and VOID YOUR
WARRANTY. Do NOT use the pump to develop a new well or purge a dirty well.
Install proper system grounding for safety and lightning protection. Although the warranty does NOT
cover damage caused by ACTS OF GOD, proper grounding can significantly reduce the chance of
extreme damage. See Section 5.8 Grounding and Lightning Protection.
Follow all wire sizing recommendations on pump data sheets. Under-sizing the wires can cause the
pump to experience low power failure.
Do not touch controller input or pump wires together to test for a spark.
Do not run the pump dry.
The cable splice must make a water-tight seal to the OUTER JACKET of the pump cable. See Section 7.3
Splicing the Wires.
There are potential hazards in handling any heavy mechanical assembly. If you have any doubts about
your ability to perform the Hand Installation SAFELY, please hire a professional pump installer. Do not
use a winch or a vehicle. See Section 8.3 Hand Installation.
Do not run the pump against a blocked or restricted outlet.
Please pay close attention to the following symbols throughout this guide:
CAUTION: disregarding may
result in damage to equipment
and VOIDING OF WARRANTY
WARNING: disregarding may
result in SERIOUS INJURY OR
DEATH
To Next Page
Loading...