23
[Figure 36]
[Figure 37]
movable
knife
fixed
blade
thread trimming cam following crank
Adjusting fixing blade and movable knife
a) Like in Figure 36, the standard position is where
the cut part of the movable knife is aligned with the
center of the fixed blade.
b) When partⓐ becomes bigger in Figure 36, three
pieces of threads are to be produced, causing the
thread missing after the trimming. If partⓑ
becomes bigger, it can cause a trimming miss. So
be cautious in adjusting the right position.
Adjusting the trimmer driving part
a) The standard assembly position is shown in Figure
37.
b) Fix the thread trimming following crank to the
trimming shaft as shown in the figure.
c) Fix the stopper lever to the bed so that the lever can
smoothly rotate in a range where the gap of the
trimming shaft does not occur.
stopper lever
Adjusting the thread trimmer solenoid
a) Working amount of the thread trimming solenoid
① The standard working amount of the thread
trimming solenoid is 4.6mm as shown in Figure
38.
② Use the thread trimming solenoid stopper nut to
control the working amount.
4.6mm
stopper nut
[Figure 38]
91.2mm
To Next Page
Loading...
