119
Function No. : 005 Function Name : Lower thread counter counting method
Function No. : 006 Function Name : Use of products counter
The method of counting for the lower thread shall be determined.
Counting by adding the number of finished sewing until reaching the target number (default value)
[ Contents ] Whenever sewing of a design is fully completed, the number is counted up.
[ Caution ] The timing for lower thread replacement is not indicated.
005. Bobbin Count
1) UP_COUNT
Setting
Value
Counting by reducing the number of finished sewing from the target number
[ Contents ] Whenever sewing of a design is fully completed, the number is counted down.
2) DN_COUNT
Counting by adding the number of finished sewing by design
[ Contents ] When there are many identical designs included within a pattern, the number is
counted by raising up the number whenever sewing of the design is completed.
[ Caution ] The timing for lower thread replacement is not indicated.
3) DESIGN_UP
Counting by lowering the number of finished sewing from the target number
[ Contents ] When there are many identical designs included within a pattern, the number is
counted by lowering the number whenever sewing of the design is completed.
The initial value of the lower thread counter shall be set before use.
4) DESIGN_DN
It is to set use of products counter.
It is not to use the products counter
[ Contents ] Products counter is not used that informs products quantity whenever
each operation finishes figure increases once by one.
[ Caution ] Products counter on the LCD screen is not used.
006. Prodct Count
1) DISABLE
Setting
Value
It is to use the products counter. (Factory installed condition)
[ Contents ] Products counter is used that informs products quantity whenever each
operation finishes figure increases one by one.
2) ENABLE
To Next Page
Loading...
