SunStar SPS/A-Pattern Series - Page 132

132
Function No. : 031 Function Name : Detecting the stitch number in starting sewing
Function No. : 032 Function Name : Detecting the stitch number during sewing
It is to set the number of stitches when sewing operation starts.
[ Caution ] This function is not available of Function No. 020. "Thrd Dectect" sets as
"1) DISABLE".
It is to set to detect the number of stitches. (Factory installed condition :
" 5 " ),
(SPS/C-5050, 805010)
[ Contents ] If you start sewing operation under the condition that theres no thread
or thread is cut, the machine detects the condition directly and make a
decision when operation stops. For example, if you set "0", as soon as
the machine detects no thread available, the machine stops operation.
[ Caution ] In case that set value is small, misdetection can occur.
031. Thrd Stitch 1
0~15
Setting
Value
It is to set the number of stitches during operation.
[ Caution ] This function is not available if Function No. 020. "Thrd Detect" sets as
"1) DISABLE".
It is to set to detect the number of stitches. (Factory installed condition : " 3 " ),
(SPS/C-5050, 80505)
[ Contents ] If thread is cut during operation, the machine detecting the condition
directly and make a decision when operation stops, For example, if you
set "0", as soon as the machine detects no thread available, the
machine stops operation.
[ Caution ] In case that set value is small, misdetection can occur.
032. Thrd Stitch 2
0~15
Setting
Value
Function No. : 033 Function Name : Use of trimming function
It is to set if the machine uses the trimming function or not.
Trimming function is not available.
[ Contents ] If the machine gets trimming code within pattern data or detects thread
cut during operation, the machine does not perform the trimming
function.
033. Trim En/Dis
1) DISABLE
Setting
Value
Trimming function is available. (Factory installed condition)
[ Contents ] If the machine gets trimming code within pattern data or detects thread
cut during operation, the machine performs the trimming function.
2) ENABLE