SunStar SPS/A-Pattern Series - Page 142

142
Function No. : 059 Function Name : Left feed plate duty
Function No. : 060 Function Name : 2 step stroke duty
Function No. : 061 Function Name : Reverting device duty
It is to set the maintenance capacity of solenoid in left feed plate.
It is to set the amount of maintenance current permitted to solenoid.
(Factory installed condition : 80%)
[Contents] In case of using solenoid in left feed plate, it sets the power that keeps the
relevant operation by permitting the adjusted current through duty to the
solenoid.
059. FFL Duty
30~80%
Setting
Value
It is to set the maintenance capacity of solenoid in 2 step stroke.
It is to set the amount of maintenance current permitted to solenoid.
(Factory installed condition : 80%)
[Contents] In case of using solenoid in 2 step stroke, it sets the power that keeps the
relevant operation by permitting the adjusted current through duty to the
solenoid.
060. TS Duty
30~80%
Setting
Value
It is to set the maintenance capacity of solenoid in reverting device.
It is to set the amount of maintenance current permitted to solenoid.
(Factory installed condition : 80%)
[Contents] In case of using solenoid in reverting device
, it sets the power that keeps the
relevant operation by permitting the adjusted current through duty to the
solenoid.
061. RV Duty
30~80%
Setting
Value