SunStar SPS/A-Pattern Series - Page 146

146
Function No. : 067 Function Name : Number of stitches to decelerate before ending work
Function No. : 068 Function Name : Decelerating speed before ending work
It is to set the stitch number of when to decelerate before ending the work.
It is to set the number of stitches when the machine should decelerate.
(Factory installed condition : SPS/A/B-1306, 1507, 1310, 1811, 5030 : 2
SPS/A/B-2516 : 5
SPS/C-Series : 4)
[Contents] It is to set the number of stitches when the machine should start decelerating
before ending the operation.
067. Decel Stitch
2~16 Stitch
Setting
Value
It is to set the speed the machine should decelerate before ending the work.
It is to set the speed to decelerate before ending the work.
(Factory installed condition :
" 400 " , SPS/C-Series : Factory installed condition " 200 " )
[Contents] The speed must be decelerated before ending the work.
The decelerating speed is set here.
068. Decel SPM
200~500spm
Setting
Value
Function No. : 066 Function Name : Set the clamp when the chain is used.
When the chain function is used, the clamp up/down can be set.
The clamp down setting is unused (default).
The clamp down setting is used.
[Contents] In case where three patterns are used consecutively, when the first pattern work is
finished, the second pattern is automatically called, and the clamp ascends.
Therefore, after the pattern work, the clamp ascends.
[Contents] In case where three patterns are used consecutively, when the first pattern work is
finished, the second pattern is automatically called, and the clamp descends. When
the second pattern work is finished, the third pattern is automatically called, and the
clamp descends. After the last third pattern work is finished and the machine returns
to the first pattern, the clamp ascends.
066. Chain Clamp
1)DISABLE
2)ENABLE
Setting
Value