SunStar SPS/A-Pattern Series - Page 179

175
Calling the pattern : Calling patterns from memory or floppy disks
Bobbin wind
Using the counter : Using the bottom thread counter and quantity control counter
Setting the extension and reduction Chain sewing : Performing the chain sewing
Setting the parameter related to general sewing Pattern programming : Generating the pattern that users want
Bobbin wind
Using the counter : Using the bottom thread counter and quantity control counter
Setting the extension and reduction
Chain sewing : Performing the chain sewing
Calling the pattern : Calling patterns from memory or floppy disks
➞➞ ➞
➞
➞
➞
Mode key
“3. BOBBIN WIND”
Input of initial value of bottom thread counter
Rate for horizontal ext./red.
Rate for vertical ext./red.
Input of initial value of quantity control counter
Calling the pattern
➞
➞
➞
Input of initial value with digit keys
Input of initial value with digit keys
Input of pattern no. with
digit keys
Starting by left pedal Ending by right pedal
➞
➞➞
Input of setting value
with digit kerys
➞
Input of setting value
with digit keys
Selection of chain no.
Selection of pattern no.
Repeat as much as the chain sewing number
➞
➞
➞➞
Input of number
with digit keys
➞
Input of number
with digit keys
Reference
1. If the READY LAMP turns on or the upper feed plate is on the bottom, it can be impossible
to use a specific key. In that case, operate the machine after pressing key.
2. After pressing, key, perform thread insertion.