26
1-4) Program Example 4 : Pattern Generation by Using the Second Origin and Pause
To program as below, input as the following orders : JUMP → SEC_Org → JUMP → CIRCLE →
TRIM → PAUSE → JUMP → LINE → TRIM
P1
(PAUSE)
(0,0)
(JUMP)
D. After pressing JUMP key, make the second
origin move to the coordinates (For example,
X:00000 Y:00300) you want by using direction
keys, then press PNT SET key.
E. By pressing EXE key, after operating the
pattern data, the feed plate moves according to
the operated pattern data.
004:JUMP
X:00000
Y:00300
N:001
JUMP NONE
X:00000A N:00027
Y:00300A
Function Code?
ORIGIN
X:00000A N:00000
Y:00000A
Function Code?
A. Insert a USB flash drive into the terminal.
B. Press MODE key.
C. By using direction keys , move to “2.
Program” menu, then press ENTER key. At
this time the upper feed plate descends, and
moves to the origin.
<< Main Menu >>
2. Program
3. Bobbin Wind
4. Machine Test
(SEC_ORG)
P2
P3
(CIRCLE)
(LINE)
P5
P7
P4
P6
To Next Page
Loading...
