SunStar SPS/A-Pattern Series - Page 28

28
CIRCLE NONE
X:-0100A N:00098
Y:00000A
Function Code?
TRIM NONE
X:-0100A N:00099
Y:00000A
Function Code?
<Function Code>
002:PAUSE <
003:EMPTY
004:JUMP
004:JUMP
X:00100
Y:00200
N:001
JUMP NONE
X:00100A N:00125
Y:00200A
Function Code?
<Function Code>
007:LINE <
008:CURVE
009:ARC
L. By pressing EXE key, the feed plate moves
according to the operated data after operating
the pattern data.
M.
By pressing TRIM key, input the code for trim.
Then, after appearing “00:TRIM”on the screen
for a moment, then a screen of the right side
appears.
N. After pressing CODE key, input the three digit
numbers if you know the pattern programming
related function code, but if you don’t know it,
press ENTER key and move to “002: PAUSE”
by using direction keys , then press ENTER
key.
O.
After pressing JUMP key, move to the one
random coordinates of straight line (for example,
X:00100 Y:00200)by using direction keys, then
press PNT SET key.
P. By pressing EXE key, the feed plate moves
according to the operated data after operating
the pattern data.
Q. After pressing CODE key.
If you know the function number related to
pattern programming, input three-figure number
and if you do not know the number, press
ENTER key and transfer to “007:Line”menu
by using direction key , and then press
ENTER key.
Ref.)“LINE”and “CURVE”function is set to
use with hot key on the operation
panel and so you may press this key.