FORM NO. 660769 REV. C PAGE 30
Jam Nut
Cylinder Rod
Threaded Rod
2-N
Cylinder length adjustment,
Locking Jam Nut
Steps:
1. Confirm the jam nut and threaded rod are fully threaded into cylinder rod, so that
no threads are showing.
2. Confirm both cylinder assemblies are the same length, when measured pin to pin.
3. Adjustment can be made by turning the flange with a pipe wench.
4. IMPORTANT: With a pipe wench on the flange, and adjustable wrench on jam
nut, tighten jam nut against the flange.
5. Do not mar the cylinder rod.
6. Keep all plastic “spacer pucks” in place on cylinder rod until final stage.
Spacer Pucks
Flange
Cylinder Rod
Cylinder
To Next Page