Sunstream SWIFTSHIELD A Series - Assembly Instructions and Tools; Required Tools for Assembly

FORM NO. 660769 REV. C PAGE 6
ASSEMBLY INSTRUCTIONS
If you have any questions during the assembly process, please call your local dealer or
Sunstream® at (253) 395-0500.
Sunstream® recommends at least 2 people for assembly.
Before beginning assembly, find a nice flat, level area with room to work and set up your
parts. Read ahead to the installation procedure to determine the best location to start.
Tools Required:
Sunstream® recommends the following tools for ease of assembly.
 Box Knife (to open packaging)
 9/16” Socket
 3/4” Socket
 7/8” Socket, or adjustable wrench
 1” Socket, or adjustable wrench
 Socket wrench
 Torque wrench (ft-lbs)
 Small adjustable wrench
 1/2” Combination wrench
 9/16” Combination wrench
 3/4” Combination wrench
 32mm Open end wrench, or adjustable wrench
 Pipe wrench with at least 2” opening
 Diagonal cutters
 Mallet
 Anti-Seize (to be used on all threaded fasteners)
 Cable ties
 7/32” Allen key
 Needle nose pliers
 Snap ring pliers
 Large Flat head screw driver
 Cordless drill
 13/32” drill bit
 Tape measure
 Level
 SunFluid
Torque values: 3/8-16 SS Bolt 20 lb-ft