Sunstream SWIFTSHIELD A Series - Custom Trimming Crossbeam; Trimming the Crossbeam; Custom Trimming Wind Guide Pipe; Trimming the Wind Guide Pipe

FORM NO. 660769 REV. C PAGE 46
Trimming the Crossbeam
1. Cut same distance off of either end of crossbeam.
2. Using a 13/32” drill bit drill new holes in crossbeam end as shown.
Trimming the Wind guide pipe
1. Cut same distance off either end of wind guide pipe.
5. Place black plastic cap back in tube. Using a 5/32” (.156) drill bit, drill three pilot
holes into black plastic cap.
6. Using existing screws, secure black plastic cap back onto tube.