SunSun CBG-800 Manual

UV Sterilizer Instructions
Cleaning and Changing Part:
1. Unplug the power and pour out the water.
2. Pull out the motor from the filter body.
3. Clean the impeller and change UV bulb if necessary.
4. Take out the quartz tube and clean the surface.
5. Check if the quartz tube and O-ring are in good condition (change if necessary).
6. Assemble the parts back together.
Product Spec：
Model
Flow Rate
UV Wattage
Suitable
Aquarium Size
Product Dimension
CBG-500 500L/h
(132GPH)
5W 38~115L (10-
30GAL)
192x110.5x165mm
CBG-800 800L/h
(211GPH)
5W 75~190L (20-
50GAL)
229x127.5x179mm
Troubleshooting：
Problem
Cause
Solution
Dirty Water
Beneficial bacteria are not
established in the new filter.
Dose some bacteria into the
filter and tank (learn more
about the Nitrogen Cycle in
Aquarium Online).
Not the right size Upgrade to a larger filter
Too many livestock
For reference only: 1 inch of
fish per gallon of tank water
Dirty filter pads Clean the filter pads
Dirty quartz tube Clean the quartz tube
Water is extremely dirty Perform a 50% water change
The UV Light Is Not On
Filter is not plug into power
Plug the filter to power outlet
UV bulb burn out
Replace 5W UV bulb
The On/Off switch in Off
position
Push the switch to the On
position
No Water Coming Out No water in filter body Put tank water in filter body
Filter not plugged into power
Plug filter to the power outlet
Intake cover clogged
Clean intake cover
Replacement Parts:
1. UV bulb (suggest changing after 8000 hours of usage)
2. Filter pads and media
3. O-ring

SunSun CBG-800 Specifications

General

Brand	SunSun
Model	CBG-800
Category	Water Filtration Systems
Language	English