To Next Page

To Previous Page

Stability

The temperature of the transported liquid should not exceed +35°C in permanent operation.

The transport of aggressive fluids (acids, alkalis, etc.) as well as of abrasive substances (e.=g. sand)

must be avoided.

Electrical connection

 The electrical connection takes place via an electrical safety socket 230=V ~ 50=Hz. Fuse pro-

tection at least 10=A.

 The engine is protected against overloading or blocking by means of an integrated motor pro-

tection. In case of overheating the pump is turned off automatically due to the integrated over -

heating protection and after the pump has cooled down, it starts automatically.

Power connection

The pond pump is equipped with a safety plug. The device is designed to be connected to an isolated

ground receptacle with 230 V ~ 50=Hz. Make sure that the socket outlet is sufficiently fused (at least

6=A) and safe. Insert the plug in the socket outlet and the pond pump is ready for use.

Note: Installation

Please position the pump under water and make sure that no water gets into the socket.

Fig. 1: The pump is to be installed as follows: in a fixed position with a fixed or flexible hose.

Use as Submersed Pump (see fig. 1)

Immerse the pump into the pond water, so that it fills with water.

To avoid the premature clogging of the filter, position the pump above the pond sludge.

The pump is started by plugging it into the mains plug.

Commissioning

After reading the installation instructions carefully, the pump can be started considering the following

aspects:

 Check if the pressure pipes have been installed properly.

 Make sure that the electrical connection is 230=V ~ 50=Hz.

 Check if the socket is in proper working order.

 Make sure that moisture or water never reaches the mains connection.

 Avoid the pump from operating dry.

 Do not use the pump without a filter basket, as this protects the pump from large debris which

can lead to blockage of the pump.

http://www.WilTec.de

http://www.aoyue.eu 12 2020-1

http://www.teichtip.de

SunSun NEO Series User Manual

Questions and Answers: