SUNTEC Klimatronic Progress 7.0 plus - Troubleshooting Common Issues; Unit Not Starting or Not Cooling; Noisy Operation and Error Codes; Operation, Smell, and Filter Questions

7
Troubleshooting
Troubles
Possible Causes
Suggested Remedies
Unit does not start when pressing POWER
button
- Water full indicator lamp blinks, and water tank
is full.
Dump the water out of the water tank.
- Room temperature is higher than the setting
temperature. (Electric heating mode)
Reset the temperature
- Room temperature is lower than the setting
temperature. (Cooling mode)
Reset the temperature
Not cool enough
- The doors or windows are not closed.
Make sure all the windows and doors are
closed.
- There are heat sources inside the room.
Remove the heat sources if possible
- Exhaust air hose is not connected or blocked.
Connect or clean the exhaust air hose.
- Temperature setting is too high.
Reset the temperature
- Air inlet is blocked.
Clean the air inlet.
Noisy
- The ground is not level or not flat enough
Place the unit on a flat, level ground if possible
- The sound comes from the flowing of the
refrigerant inside the air conditioner
It is normal.
several operation icons will blink
- at a room temperature higher or equal 18°C, Auto mode and cooling mode will work together.
If the room temperature is equal to or above 18 ° C, the unit can cool in the automatic mode. At
lower temperatures the device will protect the compressor by automatically switching into ventilation
mode.
E0 Code
There is evidence that this error massage is
caused to a room temperature which is too high.
It can also caused by a temporary fault at the
rating between incoming- and outcoming
temperature.
Please turn off the unit and turn in on after 30
minutes. If this fault is everlasting, your
PROGRESS unit should be checked by a
professional.
E2 Code
Water tank full
Please empty the water tank.
Can I switch the PROGRESS unit on
immediately after unpacking it?
No.
The PROGRESS unit must be placed upright for
at least 24 hours after every transport.
Otherwise the compressor may be damaged
and there is no capacity.
When switching on the PROGRESS unit I sense
a smell. What should I do?
Production-related cause or incorrect storage of
unit at e.g. dusty areas.
Odour development can arise on first use and
after a longer period of non-use by storing in
unsuitable areas (e.g. dusty areas).
Run the unit for ½ a day. The smell will
disappear after a while. In the case of intensive
odour development, air the room.
Can I operate the PROGRESS unit WITHOUT
the extract air hose?
Yes, but only in dehumidification mode.
To achieve temperature adjustments, surplus
coldness must be discharged.
At which intervals should the activated carbon
filter of the PROGRESS unit be replaced?
To use the purpose of the filter fully, it should be
replaced every 6 months.