SUNTEC SP500C Pro - Operating Procedures; LCD Display Functions

Position the dehumidifier
Before you turn on the machine, make sure there is enough space around the
machine. Keep it away from anything that could prevent airflow into and out of the
unit.
CAUTION! Never operate the Suntec SP dehumidifiers at temperature above 40
o
C.
It could damage the machine.
Operating Your Dehumidifier
Place the dehumidifiers in upright position
If the dehumidifier has been in a horizontal position for any time over a few minutes,
you must set it upright (vertical) for 45 minutes before starting.
Connect drainage system
You can find the hose wrapped around in the accessories pack. Unwrap the entire
hose, plug it into the water drain hose hole and run it into a drain, or bucket.
Note: Please find a suitable piping to connect the Condensation Pipe Connector at
the bottom of the machine if you find any condensation water leak out from there.
Plug in the electrical cord
Locate the electrical cord. Plug it into a standard outlet with the correct voltage and
amperage for the unit. If the unit experiences a loss of power, which can result from
a power interruption and overheated.
LCD Display – Cont.
“TOTAL” CLOCK. While “TOTAL”
CLOCK time is chosen, “TOTAL” wording
in the square box will flash for 3 sec. The
4 digits show how many DAYS the
machine has been used.
“JOB” CLOCK. While “JOB” CLOCK
time is chosen, “JOB” wording in the
square box will flash for 3 sec. The four
digits display how many HOURS and
MINUTES either the CURRENT JOB is
running or the LAST JOB has been run.
“
o
F” TEMPERTURE. While “
o
F”
TEMPERTURE function has been
chosen, “
o
F” wording in the square box
will flash for 3 sec and 3 digits figures
display the current ambient “
o
F”
temperature.
“
o
C” TEMPERTURE. While “
o
C”
TEMPERTURE function has been
chosen, “
o
C” wording in the square box
will flash for 3 sec and 2 digits figures
display the current ambient “
o
C”
temperature.