Sunvic SELECT 207 XLS User Manual

Select 207 XLS User / Installation Instructions Page 2 of 8
IMPORTANT:
These settings should only be changed by a qualified person.
Contact your installer.
The 24 Hr. programmer option runs the same programme every day.
The 5day/2day programmer option allows different ON/OFF times at weekends.
The 7 day programmer option allows different ON/OFF times for each day of the week.
The unit is designed to eliminate the possibility of accidental changes to your programme.
Buttons normally visible, only affect your set programme temporarily. All buttons which can
permanently change your programme are located behind the flip down fascia.
SELECTING OPERATING MODE
The heating and hot water mode select buttons are used to set the operating mode for
Central heating and Hot water respectively. Each has 4 modes as described:
ON: Central heating and/or hot water on continuously. (I.E. on all the time)
AUTO: Central heating and/or Hot water will be switched ON or OFF as programmed
ALLDAY: Central heating and/or Hot water will be switched ON only once each day
It will be switched ON at the first ON time and OFF at the last OFF time
OFF: Central heating and/or Hot water will be continuously OFF
INTRODUCTION
This central heating programmer can automatically switch your central heating and hot water ON & OFF,
independently, up to 3 times a day at whatever times you chose.
During installation, the installer selects 24 Hr., 5 day / 2 day or 7 day programming and 2 or 3 ON/OFF periods per
da
y,
via the 4
p
osition DIP switches on the back of the unit.
(
See installation instructions
)
.

Sunvic SELECT 207 XLS Specifications

General

Brand	Sunvic
Model	SELECT 207 XLS
Category	Switch
Language	English