!
120
However, language setting, LCD contrast
and total energy offset (only to be used
in the event of replacement) must be
configured directly on the unit. If you wish
to configure the solar inverter without
an external laptop or PC, or to change the
language setting, please follow the
instructions below:
Direct configuration of the solar inverter
occurs in operation!
Please note that the unit is under DC
voltage for configurations via the keys.
Danger to life!
Please observe all essential regulations for
«Working under voltage»!
Configurations
The solar inverter is basically configured
with the Sunways NT Monitor program,
using a laptop or PC (see enclosed CD).
Please read the chapter 3.1 «System
Monitoring and Diagnosis» and 3.2
«Sunways NT Monitor».
To Next Page
Loading...
