SUNWIND Smart Michigan - Match Lighting; Using the Grill

Sunwind Gylling AS
Cleanyourgrillaftereachuse.DONOTuseabrasiveorammablecleaners,asitwilldamage
thepartsofthisproductandmaystartare.Cleanwithwarmsoapywater.
If the burner does not light, turn the gas control knob off and wait 5 minutes to let the
gas clear before you try again.( please see the 5.3 Installing the gas cylinder)
Match lighting
IMPORTANT!
A match lighting hole is located
on the left side of the rebox.
Match lighting instructions:
1.Readallinstructionsbeforelighting.
2. Openlidduringlighting.
3. Makesurethegascontrolknobisin“OFF”position.
4. Unfoldsidetablesintotheopenposition.
5. Strikealongwoodenmatchandpositiontheburning
 matchthroughthematchlightingholeinthereboxbottom.
 Placetheamenearthebottomedgeoftheburner.
6. Pushdownandturntheburnercontrolknobcounter-clockwisetothehighsetting.
7. Theburnershouldlight.Theamewillcarryaroundtheburner.Allowgrilltopre-heatwith
 thegrilllidclosedfor2-3minutesbeforecooking.

Caution:
Donottouchanyhotgrillparts.Theoutsideofthegrillbottomespeciallybecomesveryhot
duringuse.Useprotectiveglovestohandleanypartsthatmightbecomehotduringuse.
Using the Grill
Inspecttheburneramebylookingthroughthematchlightingholes.

36
English