SUPAIR STRIKE 2 - Connecting the Wing to the Harness; Connection wing - harness; Installing the accelerator

Harness User’s manual | STRIKE 2
SUPAIR | STRIKE 2 | page 28
Install the accelerator by following the previous ins-
tructions.
Connect it to the wing using the split hooks.
Once the accelerator/speedbar is connected, adjust
its length according to your measurements.
Without twisting the risers, connect them to the har-
ness attachment loops using the self-locking carabi-
ners.
Check for the risers to be properly positioned and
untwisted. The «A» risers must be located at the
front and facing the flight direction (see diagram).
Lastly, check for the main self-locking carabiners to
be fully closed and locked in place.
For correct use, there
must not be any ten-
sion at the split-hook
level when the accele-
rator/speedbar line is
fully relaxed.
Connection wing - harness
Installing the accelerator
1
3
5
2
4
6
7 8
1
3
5
2
4
6
7 8
Flight direction
Plume Grivel
Carabiners
Flight direction
Connect
CONNECTING THE WING TO THE HARNESS