15
16
Try to fit the H6 into V1 and use instant
glue to secure the H6 in place.
Use sanding paper to trim the surface.
Use sanding paper to trim the top edge
into round edge.
Close view of the round edge.
Place V2, V3, V4, V5, H5 on the working
table for assembling elevator.
Try to fit V4 into V2; fit H5 and V5 into V3.
Use instant glue to secure V4, H5 and V5
in place.
Use wooden planning tool to trim the
leading edge of the V3 into V shape (30
degree).
Close view of the V shape.
Try to fit the V2 into V3 and use instant
glue to secure them in place.
Use sanding paper to trim the surface of
the rudder. The thickness is 5mm; don't
trim too much.
Use sanding paper to trim the outer edge
of the rudder into round edge (R5).
Close view of the round edge.
To Next Page
Loading...
