7
3. Switch on the power and speed controller button. Check the battery status. Switch the button into Drive or
Revise, and move the dolly by the speed controller knob. The speed can be various from 0-2.5km/h. (See
Figure 13)
4. Shut down the power after use. And park the dolly in the correct position. PLEASE RECHARGE THE BATTERY
WITHN 3 MONTHS OTHERWISE THE LEAD ACID BATTERY MAY BE DESTRIED.
OVERLOAD PROTECTION
The dolly equipped with overload protection system, will shut down while over loaded. This will protect the potential
risk of the machine destroy. Please do not try to start when the dolly overloaded and shut down, please re-start
after the loading weight reduced within the capacity.
TROUBLE SHOOTING
R
D
Figure 13
D/R Switch
Power Supply
Battery Status
Display
Speed Control
Button
Problem(s)
Power dolly do not works.
Power dolly stop during working.
Possible Cause
Power shut down.
1. Batteries in low.
2. Power dolly overloaded.
Corrective Action
1. Check the battery status make sure it in full .
2. Check the power switch in power on status.
3. Check the connect cable without loose
1. Recharge the power dolly in full
2. Reduce the loading weight with the capacity and re-start.
To Next Page