Super Steam X5 - By using Scraper; By using cleaning solution

SUPER STEAM X564
CLEANING AND MAINTENANCE
By using Scraper
1) Make sure that the SUPER STEAM X5 is disconnected from the
power supply before maintenance.
Do not leave the steamer unaended during the lime scale re-
moval process and/or while in use.
Perform a test cleaning on a suitable isolated area aer each lime
scale removal to ensure that there is no debris le in the system.
By using cleaning soluon
1) Prepare a soluon of 1/3 white vinegar and 2/3 tap water
and add to the water tank.
2) Secure and posion the unit to ensure steam released is
aimed away from the oor or surrounding objects and surfaces. Plug
the unit in, turn the unit ON by pressing the Power Switch (O/I) and
allow the unit to produce steam unl the vinegar/water soluon is
used up.
3) Repeat the above procedure as many mes as necessary un-
l a normal steam ow rate is achieved.
4) Fill the Water Tank with fresh water and rinse out.
5) Fill the Water Tank with fresh water, aach to the unit and
release steam through the system unl the Water Tank is empty.
2) Use the Cleaning Pin to remove
scale deposits from the small hole of the
steam outlet in the Main Body, as illus-
trated in Fig. 2.
By swirling and pushing the pin up and
down you will clean the steam outlet.
Always ensure that all scale debris have
been removed from the steam outlet be-
fore reassembling.
Connue swirling Cleaning Pin unl no further debris is evident.
DANGER OF SCALDING