Superchips Pulsar LT - Clear DTCs; Auto Start;Stop Disable; DFM (Dynamic Fuel Management) Disable

13
Clear DTC’s
STEP 1 - Access the programming menu.
STEP 2 - Using +RES or -SET, select mode 50 (MPH)
STEP 3 - Press cancel cruise to select.
STEP 4 - The speedometer will sweep to 140 MPH, indicating the function is
complete.
STEP 6 - The speedometer will sweep to 140 MPH, indicating the function is
complete.
Axle Ratio Cont’d
DFM (Dynamic Fuel Management) Disable
STEP 1 - Access the programming menu.
STEP 2 - Using +RES or -SET, select mode 70 (MPH)
STEP 3 - 3. Use the +RES or –SET wheel to adjust to the desired value.
a.0 = DFM is active
b.10 = DFM is disabled
STEP 4 - Press the cancel cruise control button to save the input value.
STEP 5 - The speedometer will sweep 0 to 140 MPH indicating the function is
complete.
Disabling DFM will automatically disable Auto Start/Stop
Auto Start/Stop Disable
STEP 1 - Access the Programming Menu.
STEP 2 - Using +RES or -SET, select mode 60 (MPH)
STEP 3 - Use the +RES or –SET wheel to adjust to the desired value.
a. 0 = Auto Start/Stop is active
b. 10 = Auto Start/Stop is disabled
STEP 4 - Press the cancel cruise control button to save the input value.
STEP 5 -The speedometer will sweep 0 to 140 MPH indicating the function is
complete.