ALARM – When the “Motion Detection” function on the complete menu of the App is
activated, the “Security” camera uses its sensors to notify the user’s smartphone that a
movement has been detected inside the viewing eld.
The “Security iCM003” camera has a built-in siren which is activated by pressing the icon
in the upper-right (3 dots), followed by “Detection Alarm Settings”, and nally “Trigger
Siren”. The acoustic alarm goes o every time a motion is detected, regardless of the
status of the “Motion Detection” function (which must be activated for notications to be
received on the user’s smartphone).
ONVIF – The “Security” camera supports the “ONVIF” protocol and, through this, can be
connected to a DVR/NVR that is in turn compatible.
This connection can be activated by pressing the icon at the top right (3 dots), then
“Onvif” and, subsequently, “Onvif Switch”. Then select “Reset Password” to enter the
desired security word.
This will be entered in the dedicated section of the DVR/NVR together with the IP
address indicated on the “Smart Life®” App, if it is not automatically recognized by the
recorder.
5. SAFETY AND SECURITY INFORMATION
• Keep the “Security” camera from coming into contact with, or being in the
vicinity of, open ames or electrical discharges. The ranges of humidity and
temperature it supports are, respectively: 0% ~ 90% RH ; -10°C ~ +60°C
• Though the “Security” camera is designed and produced to guarantee the
safety and security of the user, and of environment in which it is used,
damage may still occur in situations that fall outside of normal use.
• It is recommended that only very secure passwords be used (at
least 8 alphanumerical characters, of which at least one should
be a capital letter, one a number, and one a symbol).
• Firmware updates must not be interrupted, or the camera could be damaged.
To Next Page
Loading...