12
USING THE REMOTE CONTROL
To reduce the
risk of fire or electric shock,
do not use this unit with any
solid-state speed control
device.
The remote control provided
with this unit is not considered a solid-state device. The
Air Cleaner is equipped with a REMOTE CONTROL (A) Fig.8A.
NOTE: The remote requires two (2) AAA batteries. The Battery housing is located underneath
the back cover.
Notice that the remote control has three control button (Fig. 8A): TIME (B), ON/OFF (C), and
SPEED (D). These buttons correspond to the LED sensor panel on the rear of the machine (K)
Fig. 8B.
NOTE: When the machine is connected to the power source, a green light (E) will be
activated on the panel.
To activate the blower unit, press the “ON/OFF” button (C) Fig. 8A. The machine will begin in
the default speed of Low or “L” on the sensor panel. Press the SPEED button once, and the
machine will run at the high (or “H” level). Press the SPEED button again, and the machine
will run at the medium speed (or “M”). Press the SPEED button a third time, and the
machine will return to the Low Speed mode. To turn the machine off, press the
“ON/OFF” button (C) Fig. 8A. This unit has a timer that can be set by remote control. When
the “TIME” button (B) Fig. 8A is pressed on the remote control, the machine will run for 1/2
hour. (An LED light will show up on the sensor panel (F) Fig. 8B). Pressing the “TIME” button
again will set the machine to run for one hour. Notice that the light on the sensor panel has
now moved to the 1H location (G) Fig. 8B. When the “TIME” button is pressed a third time,
the machine will run for two hours. At this point, the green light will show up under the two
hour location (H). When you press the “TIME” button the fourth time, the unit will run for
four hours. Notice that the indicator light (J) glows at the four hour mark.
All of these functions can be manually controlled by using the two buttons on the sensor
panel (K) Fig. 8B.
NOTE: The air cleaner may produce a slight odor for the first few hours of operation due
to the protective
coating
which is applied to internal components. This odor will dissipate
and should be
disr
egar
ded.
IMPORTANT:
Never
operate
the air
cleaner
without air filters in
place.
To Next Page
Loading...