13
The 3
Speed
Ambient Air
Cleaner
with
Electrostatic
Filter can be
used
in
a. Bench-top sanding
applications.
b. Circular saw
applications.
c. Dry wall
applications.
d. Shop cleaning
applications.
e. Floor sanding
applications.
f. Any other application where non-metallic dust is a
factor
.
For assistance with your machine, call us at (888) 454-3401.
CHANGING AND CLEANING FILTERS
When cleaned as directed, your electrostatic air filter will
give you many years of trouble-free use. Failure to properly
clean the filter may lessen filter effectiveness, and as with
any air filter, it is possible for an excessive dirt buildup to
cause air flow resistance sufficient to damage other
ventilation components. Depending on your specific
situation the filter should be cleaned every 4-6 weeks.
There is an “air
flow”
indicator
(A)
Fig. 9A located on the
left side of the unit. To check the filters, turn the unit
“ON”. If the indicator points to “green” (B)
Fig.
9A, the
filters are clean. Clean (or change) the filters when the
indicator points to “red”
(C)
Fig. 9A as
follows:
1. Turn the unit
“OFF”.
2. Remove the outer first stage filter (A) Fig. 9B by lifting and pulling out on the bottom
of the filter.
3. Rinse thoroughly to remove remaining dirt.
4. Drain excess water, let air dry, and reinstall.
Compressed
air can be
dangerous.
For operator safety, do not
To Next Page
Loading...