Chapter 2: Installation
2-13
ATX PS/2 Keyboard and
PS/2 Mouse Ports
The ATX PS/2 keyboard and the
PS/2 mouse ports are located on the
IO backplane. The mouse is the top
(green) port. See the table on the
right for pin defi nitions.
PS/2 Keyboard and
Mouse Port Pin
Defi nitions
Pin# Defi nition
1 Data
2NC
3 Ground
4 VCC
5 Clock
6NC
Overheat LED
Connect an LED to the JOH1 header
to provide warning of chassis over-
heating. See the table on the right for
pin defi nitions.
Overheat LED
Pin Defi nitions (JOH1)
Pin# Defi nition
1 3.3V
2 OH Active
Power LED/Speaker
On JD1, pins 1, 2, and 3 are for the
power LED and pins 4 through 7 are
for the speaker. See the tables on the
right for pin defi nitions.
Note: The speaker connector pins are
for use with an external speaker. If
you wish to use the onboard speaker,
you should close pins 6 and 7 with a
jumper.
Speaker Connector
Pin Defi nitions (JD1)
Pin# Defi nition
4 Red wire, +5V
5 No connection
6 Buzzer signal
7 Speaker data
PWR LED Connector
Pin Defi nitions (JD1)
Pin# Defi nition
1 +Vcc
2 Control
3 Control
CD1 Header
The 4-pin CD1 header allows you to
use the onboard sound for audio CD
playback. Connect the audio cable
from your CC drive to this header.
See the table on the right for pin
defi nitions.
CD1
Pin Defi nitions
Pin# Defi nition
1 Right Signal
2 Ground
3 Ground
4 Left Signal
To Next Page
Loading...